GDP data methodology adheres to accepted standard
Updated: 2016-01-25 08:04
By Xu Xianchun(China Daily)
|
||||||||
In the face of doubts over its GDP data, China is always attentive and adopts an open mind. It is willing to listen to any reasonable doubts and is willing to embrace constructive suggestions as an important reference for revisions to its GDP accounting.
But some foreign scholars argue that China's GDP growth rate is overrated as it uses the growth rate of only some industrial products to calculate the growth rate of the overall industrial added value through the method of weighted average. However, there exist obvious faults in their method of calculation.
First, the products chosen by the mare insufficiently representative. Too few categories of industrial products are chosen and such primary and traditional products as coal, oil and steel have a relatively large proportion. This results in GDP data that does not reflect the actual growth of the entire industrial sector. Given that new industrial products usually have a relatively fast growth rate, this method usually leads to the underestimation of China's industrial sector, especially at a time when the country is experiencing an economic downturn and an even more obvious slowdown in its traditional industrial output.
Being based on the quantity of industrial products, such a method also fails to reflect changes in the quality of these products. Using this method, economic growth emanating from technological progress and higher quality industrial products is usually ignored. According to the SNA, direct comparisons cannot be made for the quantities of different products if they have different qualities. A simple comparison will underestimate the economic growth caused by the higher product quality and thus the growth rate of the entire industrial sector will be underrated.
At the same time, the method also fails to reflect the changed structure of industrial products, which usually influences the growth rate of the sector. In fact, the choosing of some industrial out put is only applicable to the calculation of the growth rate of only a few industrial sectors. International practices also disapprove of such a method to calculate the growth of the entire industrial sector.
The author is deputy director of the National Bureau of Statistics.
- Global health entering new era: WHO chief
- Brazil's planning minister steps aside after recordings revelation
- Vietnam, US adopt joint statement on advancing comprehensive partnership
- European border closures 'inhumane': UN refugee agency
- Japan's foreign minister calls A-bombings extremely regrettable
- Fukushima impact unprecedented for oceans: US expert
- Stars of Lijiang River: Elderly brothers with white beards
- Wealthy Chinese children paying money to learn British manners
- Military-style wedding: Fighter jets, grooms in dashing uniforms
- Striking photos around the world: May 16 - May 22
- Robots help elderly in nursing home in east China
- Hanging in the air: Chongqing holds rescue drill
- 2.1-ton tofu finishes in two hours in central China
- Six things you may not know about Grain Buds
Most Viewed
Editor's Picks
Anti-graft campaign targets poverty relief |
Cherry blossom signal arrival of spring |
In pictures: Destroying fake and shoddy products |
China's southernmost city to plant 500,000 trees |
Cavers make rare finds in Guangxi expedition |
Cutting hair for Longtaitou Festival |
Today's Top News
Liang avoids jail in shooting death
China's finance minister addresses ratings downgrade
Duke alumni visit Chinese Embassy
Marriott unlikely to top Anbang offer for Starwood: Observers
Chinese biopharma debuts on Nasdaq
What ends Jeb Bush's White House hopes
Investigation for Nicolas's campaign
Will US-ASEAN meeting be good for region?
US Weekly
Geared to go |
The place to be |